Removal And Installation

HEADLINING


Removal and Installation


REMOVAL





1. Remove sun visor cap (1) using a remover tool (A), and then remove sunvisor assembly fixing TORX screws.
2. Disconnect vanity mirror lamp harness connector, and then remove sun visor assembly (LH and RH).





3. Rotate sun visor holder (1) (LH and RH) at approximately 90 degrees, and then pull it out to remove.





4. Insert a remover tool (A) into the gap between lane camera finisher (1), and then remove lane camera finisher (if equipped).

Triangle : Pawl

5. Remove light & rain sensor cover / rain sensor cover. Removal And Installation.





6. Disconnect harness connectors.
- Lane camera unit harness connector (1) (if equipped).
- Inside mirror harness connector (2).
- Light & rain sensor harness connector / rain sensor harness connector (3).
7. Remove assist grips





- Insert a small flat-bladed screwdriver (A) into the gap between assist grip cap (1), and then remove assist grip cap.
- Remove assist grip mounting bolts, and then remove assist grips (2).





8. Insert a remover tool (A) between luggage room lamp (1) and roof garnish to disengage the fixing metal clips, and then disconnect luggage room lamp harness connector.
CAUTION:
Apply protective tape (B) to the roof garnish to protect from damage.

Square : Metal clip





9. Insert a remover tool (A) between roof garnish (1) and body panel to disengage the fixing clips and pawls, and then remove roof garnish.

Square : Clip
Triangle : Pawl

10. Remove front pillar garnish (LH and RH). Front Pillar Garnish, "FRONT PILLAR GARNISH : Removal and
Installation".
11. Remove front kicking plate inner (LH and RH) and rear kicking plate inner (LH and RH). Body Side Welt Kicking Plate Inner, "KICKING PLATE INNER : Removal and Installation".
12. Remove dash side finisher (LH and RH). Dash Side Finisher.
13. Remove center pillar lower garnish (LH and RH). Center Pillar Lower Garnish.
14. Remove luggage side lower finisher (LH and RH). Luggage Side Lower Finisher.
15. Remove front body side welt (LH and RH) and rear body side welt (LH and RH). Body Side Welt.
16. Remove center pillar upper garnish (LH and RH). Center Pillar Upper Garnish.
17. Remove rear pillar finisher (LH and RH). Rear Pillar Finisher.
18. Remove back pillar garnish (LH and RH). Back Pillar Garnish.
19. Remove luggage side upper finisher (LH and RH). Luggage Side Upper Finisher.





20. Insert a remover tool between map lamp assembly (1) and headlining assembly to disengage the fixing metal clips, and then remove map lamp assembly.

Square : Metal clip

21. Peel off dual lock fastener between headlining assembly and roof panel.
22. Remove headlining clips located at the rear side
23. Remove headlining assembly (1) through the back door.






CAUTION:
- When removing, 2 workers are required.
- Never bend headlining when removing.
- Be careful not to scratch or damage any part of the body while taking out the headlining.
24. Remove the following parts after removing headlining assembly.
- Personal lamp assembly. Removal And Installation.
- Rear ventilator grille assembly. Rear Ventilator Grille.
- Headlining harness.

INSTALLATION
Note the following items, and install in the reverse order of removal.

CAUTION:
- Be careful not to bend headlining when installing.
- First install metal clips of map lamp assembly and clips of the rear end of headlining for positioning.