Rear Power Window LH Auto Up / Down Function Does Not Operate With Rear Power Window Switch LH
WINDOW / GLASS: POWER WINDOW CONTROL SYSTEM: Rear Power Window LH Auto Up / Down Function does not Operate with Rear Power Window Switch LH
Rear Power Window LH Auto Up / Down Function does not Operate with Rear Power Window Switch LH
DESCRIPTION
- If the auto up/down function does not operate, the cause may be one or more of the following:
- The ECU in the power window regulator motor determines that the power window regulator motor has not been initialized.
- The power window regulator switch has a malfunction.
- The Hall-IC in the power window regulator motor has a malfunction.
- There is an open or short in the wiring between the rear power window regulator switch and the rear power window regulator motor.
WIRING DIAGRAM
INSPECTION PROCEDURE
PROCEDURE
1. CHECK FOR DTC
(a) Check for DTCs Reading and Clearing Diagnostic Trouble Codes.
Result
E -- GO TO LIN COMMUNICATION SYSTEM
D -- GO TO DTC B2313
C -- GO TO DTC B2312
B -- GO TO DTC B2311
A -- Continue to next step.
2. CHECK MANUAL UP/DOWN FUNCTION (REAR POWER WINDOW REGULATOR SWITCH LH)
(a) Check that the rear door power window LH moves when the manual up/down function of the power window regulator switch is operated Component Tests and General Diagnostics.
OK:
Rear door power window LH moves.
NG -- OTHER PROBLEM (GO TO PROBLEM SYMPTOMS TABLE)
OK -- Continue to next step.
3. READ VALUE USING TECHSTREAM (REAR POWER WINDOW REGULATOR MOTOR LH)
(a) Use the Data List to check if the power window regulator motor is functioning properly Scan Tool Testing and Procedures.
RL-Door Motor
OK:
The Techstream display changes according to operation of the rear power window switch LH.
NG -- CHECK HARNESS AND CONNECTOR (REAR POWER WINDOW REGULATOR SWITCH LH - REAR POWER WINDOW REGULATOR MOTOR LH)
OK -- REPLACE REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY LH
4. CHECK HARNESS AND CONNECTOR (REAR POWER WINDOW REGULATOR SWITCH LH - REAR POWER WINDOW REGULATOR MOTOR LH)
(a) Disconnect the J10 switch connector.
(b) Disconnect the J11 motor connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
NG -- REPAIR OR REPLACE HARNESS AND CONNECTOR
OK -- Continue to next step.
5. INSPECT REAR POWER WINDOW REGULATOR SWITCH LH
(a) Remove the rear power window regulator switch Removal.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
NG -- REPLACE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY
OK -- REPLACE REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY LH