Removal

ENGINE HOOD / DOOR: HOOD LOCK CONTROL CABLE ASSEMBLY: REMOVAL

1. REMOVE ENGINE UNDER COVER ASSEMBLY (for 2GR-FE) Removal

2. REMOVE NO. 1 ENGINE UNDER COVER

3. REMOVE FRONT FENDER MOULDING SUB-ASSEMBLY LH Removal

4. REMOVE FRONT FENDER LINER LH Removal

5. REMOVE COOL AIR INTAKE DUCT SEAL Removal

6. REMOVE RADIATOR GRILLE Removal

7. REMOVE HOOD LOCK ASSEMBLY (w/o Engine Hood Courtesy Switch)

(a) Remove the hood lock nut cap.





(b) Remove the 3 bolts.





(c) Disconnect the hood lock control cable and remove the hood lock assembly.





8. REMOVE HOOD LOCK ASSEMBLY (w/ Engine Hood Courtesy Switch)

(a) Disconnect the connector.





(b) Remove the hood lock nut cap.





(c) Remove the 3 bolts.





(d) Disconnect the hood lock control cable and remove the hood lock assembly.





9. REMOVE HOOD LOCK CONTROL CABLE ASSEMBLY

(a) Disconnect the hood lock control cable from the hood lock control lever.





(b) Using a screwdriver, disconnect the clamps shown in the illustration.









HINT
Tape the screwdriver tip before use.

(c) Pull the cable from the engine compartment and remove it.