Installation

SUPPLEMENTAL RESTRAINT SYSTEM: STEERING PAD: INSTALLATION

CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing Service Precautions.

1. INSTALL STEERING PAD





Text in Illustration





(a) Check that the ignition switch is off.

(b) Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

(c) Connect the 2 airbag connectors.

NOTICE:
* Do not damage the airbag wire harness when connecting the airbag connector.
* Be sure to only connect the connectors to each corresponding color.
* Securely lock the 2 locking buttons.

(d) Connect the horn terminal.

(e) Install the steering pad.

(f) Using T30 "TORX" socket wrench, tighten the 2 bolts.





Torque : 8.8 Nm (90 kgf-cm, 78 in-lbf)

NOTICE:
Tighten the 2 bolts while holding the steering pad to prevent it from moving upward.

2. INSTALL LOWER NO. 2 STEERING WHEEL COVER

(a) Engage the 2 claws to install the lower No. 2 steering wheel cover.

3. INSTALL LOWER NO. 3 STEERING WHEEL COVER

HINT
Use the same procedure as for the lower No. 2 steering wheel cover.

4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)

5. INSPECT SRS WARNING LIGHT

Diagnosis System