Installation
SUPPLEMENTAL RESTRAINT SYSTEMS: STEERING PAD: INSTALLATION
HINT
* Use the same procedure for the 4 spoke and 3 spoke.
* The procedure listed below is for the 4 spoke.
1. INSTALL HORN BUTTON ASSEMBLY
(a) Check that the ignition switch is off.
(b) Check that the cable is disconnected from the negative (-) battery terminal.
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
(c) Connect the 2 airbag connectors to the horn button assembly.
Text in Illustration
NOTICE:
* When connecting any airbag connector, take care not to damage the airbag wire harness.
* Be sure to only connect the connectors to each corresponding color.
(d) Push in the 2 locks to install the 2 airbag connectors.
(e) Connect the horn connector to the horn button assembly.
(f) Push the horn button assembly to engage the 3 pins carefully.
NOTICE:
* Make sure that the pins are securely inserted into the steering holes.
* Make sure to engage the 2 upper pins first.
* Make sure that the horn button assembly is securely installed.
2. INSTALL LOWER NO. 3 STEERING WHEEL COVER
(a) Engage the claw and guide to install the lower No. 3 steering wheel cover.
3. INSTALL LOWER NO. 2 STEERING WHEEL COVER
(a) Engage the claw and guide to install the lower No. 2 steering wheel cover.
4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.
5. INSPECT HORN BUTTON ASSEMBLY
(a) Make sure that the horn sounds.
If the horn does not sound, inspect the horn system Symptom Related Diagnostic Procedures.
6. PERFORM DIAGNOSTIC SYSTEM CHECK
for Separate Type Yaw Rate Sensor: Separate Type Yaw Rate Sensor
for Built-in Type Yaw Rate Sensor: Built-in Type Yaw Rate Sensor
7. INSPECT SRS WARNING LIGHT
for Separate Type Yaw Rate Sensor: Separate Type Yaw Rate Sensor
for Built-in Type Yaw Rate Sensor: Built-in Type Yaw Rate Sensor