Installation

PARKING BRAKE: PARKING BRAKE PEDAL: INSTALLATION

1. INSTALL PARKING BRAKE CONTROL PEDAL ASSEMBLY

(a) Install the parking brake control pedal assembly with the bolt and 2 nuts.





Torque : 15 Nm (148 kgf-cm, 11 ft-lbf)

(b) Connect the parking brake switch connector.





(c) Engage the wire harness clamp.

(d) Install the No. 1 parking brake cable assembly with the 4 bolts and nut.





Torque : 15 Nm (148 kgf-cm, 11 ft-lbf)

(e) Install the No. 1 parking brake cable assembly to the clamp.

(f) Engage the 2 wire harness clamps.

(g) Temporarily install the lock nut.





Text in Illustration





HINT
After adjusting parking brake pedal travel, tighten the lock nut.

2. CONNECT NO. 1 PARKING BRAKE PULL ROD SUB-ASSEMBLY

(a) Connect the No. 1 parking brake pull rod sub-assembly to the parking brake control pedal assembly as shown in the illustration.





Text in Illustration





Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)

3. INSTALL NO. 2 BELT ANCHOR REINFORCEMENT SUB-ASSEMBLY

(a) Install the No. 2 belt anchor reinforcement sub-assembly with the 4 bolts.

Torque : 27 Nm (275 kgf-cm, 20 ft-lbf)

4. INSTALL YAW RATE AND ACCELERATION SENSOR Installation

5. INSTALL AIR CONDITIONING UNIT ASSEMBLY

Installation

6. ADJUST PARKING BRAKE PEDAL TRAVEL Adjustments

7. INSPECT BRAKE WARNING LIGHT Adjustments