CMBS Off Switch Test/Removal/Installation

CMBS OFF Switch Test/Removal/Installation

1. Remove the instrument fascia Instrument Fascia Removal/Installation.

2. Remove the screws and the CMBS OFF switch (A).






3. Check for continuity between the 6P connector terminals in each switch position according to the table.









4. If the continuity is not as specified, replace the CMBS OFF switch.

5. Use a diode tester between the 6P connector terminals in each switch position according to the table.






6. If the diode test is not as specified, install the CMBS OFF switch in the reverse order of removal.