Suspension Control Module: Service and Repair

Active Damper Control Unit Replacement

1. Turn the ignition switch to LOCK (0).

2. Remove the cargo rear trim panel Interior Trim Removal/Installation - Cargo Area.

3. Remove the mounting bolts, and pull out the active damper control unit (A).





4. Disconnect the active damper control unit connectors (B).

5. Install the active damper control unit in the reverse order of removal.

NOTE: Do not pinch the wire harnesses between the frame and the active damper control unit.

6. Do the memorizing rear suspension full rebound position Programming and Relearning.

7. Start the engine, then make sure there are no active damper system DTCs with the HDS.

8. Do the DAMPER FORCE OPERATION TEST in the FUNCTIONAL TESTS MENU with the HDS, then make sure the all four damper units function normally.

9. Test-drive the vehicle, and check that the active damper system indicator does not come on.