Torque Converter Housing Third Shaft Bearing Replacement

Torque Converter Housing Third Shaft Bearing Replacement

Special Tools Required

- Adjustable Bearing Puller, 25-40 mm 07736-A01000B
- Driver Handle, 15 x 135L 07749-0010000
- Bearing Driver Attachment, 42 x 47 mm 07746-0010300

1. Remove the third shaft bearing from the torque converter housing using the 25-40 mm adjustable bearing puller and a commercially available 3/8''-16 slide hammer (A).






2. Check the ATF guide plate (A), and replace it if it is damaged.





3. Install a new bearing (B) in the direction shown.

4. Drive the bearing (A) into the torque converter housing using the 15 x 135L driver handle and the 42 x 47 mm bearing driver attachment; install the bearing to a depth (B) of 0-0.07 mm (0-0.003 in) below the torque converter housing surface (C).