A/T Housing Third Shaft Bearing Installation

A/T Housing Third Shaft Bearing Installation

Special Tools Required

- Driver Handle, 15 x 135L 07749-0010000
- Oil Seal Driver Attachment, 71.5 mm 07GAD-SE00100

1. Install the third shaft bearing (A) in the direction shown.






2. Expand the snap ring using snap ring pliers, and insert the bearing part-way into the transmission housing.

3. Release the snap ring pliers, then push the bearing down into the transmission housing until the snap ring snaps in place around it.

4. After installing the bearing, check that the snap ring (A) is seated in the bearing and the housing groove, and that the snap ring end gap (B) is 0-7 mm (0-0.28 in).






5. Install the reverse idler gear A/T Housing Reverse Idler Gear Removal/Installation.