Rear Power Window Motor Test

Rear Power Window Motor Test

1. Remove the door panel Front Door Panel Removal/Installation, and disconnect the rear power window switch 14P connector (A).






2. Test the power window motor in each direction by connecting battery power and ground according to the table. When the motor stops running, disconnect one lead immediately.





3. If the motor does not run or fails to run smoothly, go to step 4.

4. Disconnect the 6P connector (A) from the rear power window motor (B).






5. Check for continuity between rear power window motor 6P connector terminals No. 1 and No. 2 and rear power window switch 14P connector terminals No. 1 and No. 7 respectively. There should be continuity.

- If there is no continuity, repair an open in the wire.
- If there is continuity, replace the power window motor.









6. After replacing the power window motor, reset the power window control unit Testing and Inspection.