Air Bag Control Module: Service and Repair

SRS Unit Replacement

Removal

1. Do the battery terminal disconnection procedure Procedures, then wait at least 3 minutes before starting work.

2. Remove the center console Center Console Removal / Installation.

3. Disconnect the SRS unit connector A (28P), SRS unit connector B (28P), and SRS unit connector C (16P).





4. Remove the TORX bolts (D) using a TORX T30 bit, then pull out the SRS unit.

Installation

1. Install the SRS unit (A) with a new TORX bolts (B) using a TORX T30 bit, then connect the connectors (C) to the SRS unit; push them into position until they click.

NOTE: Be sure the SRS unit is sitting squarely against it's bracket before torquing the TORX bolts.





2. Do the battery terminal reconnection procedure Procedures.

3. Do the ODS unit initialization.

4. Check the operation of the ODS unit with the HDS Component Tests and General Diagnostics.

5. Confirm proper SRS operation: Turn the ignition switch to ON (II), and check that the SRS indicator comes on for about 6 seconds and then go off.

6. Install the center console Center Console Removal / Installation.