A/T Secondary Shaft 1st Gear One-Way Clutch Inspection

A/T Secondary Shaft 1st Gear One-Way Clutch Inspection

1. Hold the 1st-hold clutch hub (A), and turn 1st gear (B) in the direction shown to be sure it turns freely. Also make sure 1st gear locks in the opposite direction.





2. If any problem occurs on the 1st gear one-way clutch, replace the 1st clutch hub (C). The 1st gear one-way clutch is not available separately from the 1st clutch hub.

3. Also check 1st gear and the 1st-hold clutch hub for wear and damage. If 1st gear and the 1st-hold clutch hub are worn or damaged, replace the damaged part, refer to 1st Clutch Hub Replacement A/T Secondary Shaft 1st Clutch Hub Replacement.