Torque Converter Housing Park Lever Shaft Bearing Replacement

Torque Converter Housing Park Lever Shaft Bearing Replacement

Special Tools Required

- Bearing Remover Shaft Set, 12 mm 07936-166010A
- Remover Handle 07936-3710100
- Slide Hammer 07936-371020A
- Driver Handle, 15 x 135L 07749-0010000
- Attachment, 22 x 24 mm 07746-001A800

1. Remove the park lever shaft bearing from the torque converter housing using the bearing remover shaft set (12 mm), remover handle, and the sliding hammer weight.






2. Install a new bearing until it bottoms in the torque converter housing using the drive handle (15 x 135L) and the attachment (22 x 24 mm).