Rear Door Window Glass: Adjustments

Front and Rear Door Glass Adjustment

NOTE:

- Check the weatherstrip and the glass run channel for damage or deterioration, and replace them if necessary.
- Wipe the run channel clean with a shop towel.

1. Place the vehicle on a firm, level surface.

2. Remove these items:

- Door panel
- Front door Front Door Panel Removal / Installation

- Plastic cover
- Front door

3. Carefully move the glass (A) until you can see the glass mounting bolts (B), then loosen them.

Front





Rear





4. Push the glass against the glass run channel (C), then tighten the glass mounting bolts.

5. Check that the glass moves smoothly.

6. Raise the glass fully, and check for gaps. Also make sure that the glass (A) contacts the glass run channel (B) evenly.






7. Attach the plastic cover making sure it is sealed around its outside perimeter to seal out water.

8. Reinstall the door panel:

- Front door Front Door Panel Removal / Installation
- Rear door Rear Door Panel Removal / Installation

9. Check for water leaks. Run water over the roof and on the sealing area as shown, and note these items:

- Use a 12 mm (1/2 in) inside diameter hose (A).
- Adjust the rate of water flow as shown (B).
- Do not use a nozzle.
- Hold the hose about 300 mm (12 in) away from the door (C).





10. Do the power window control unit resetting procedure Testing and Inspection.