Hatchback

MASTER SWITCH / INPUT TEST (HATCHBACK)

NOTE: The control unit is built into the power window master switch, and only controls driver's door window operations.

1. Remove the driver's door panel and disconnect the 10-P connector from the master switch.







2. Inspect the connector and socket terminals to be sure they are all making good contact.
* If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.
* If the terminals look OK, make the following input tests at the connector terminals.
- If a test indicates a problem, find and correct the cause, then recheck the system.
- If all the input tests prove OK, the power window master switch must be faulty; replace it.