Transmission Position Sensor/Switch: Service and Repair

SRS components are located in this area. Review the SRS component locations, precautions, and procedures under Air Bags before performing repairs or service.

1. Remove the console, then disconnect the 12-P and 2-P connectors from the A/T gear position switch.




2. Remove the two position switch mounting bolts.
3. Position the slider on the new switch to [N] as shown above.
4. Shift the shift lever to [N], then slip the switch into position.
5. Attach the switch with the two bolts.
6. Test the switch in the [P] and [N] positions. You should be able to start the engine with the shift lever in position [N] anywhere in the range of free play.
7. Connect the 12-P and 2-P connectors, clamp the harness, and install the console.