Bearing Removal and Installation

Removal and Installation

Special Tools Required
- Driver 07749-0010000
- Seal driver attachment 07GAD-PG40100 or 07GAD-PG40101
- Attachment, 62 x 68 mm 07746-0010500
- Attachment, 72 x 75 mm 07746-0010600

NOTE: Coat all parts with ATF before assembly.





1. To remove the mainshaft bearing (A), countershaft bearing (B), and secondary shaft bearing (C) from the transmission housing, expand each snap ring with the snap ring pliers, then push the bearing out.

NOTE: Do not remove the snap rings unless it's necessary to clean the grooves in the housing.

2. Install the bearings in the direction shown.
3. Expand each snap ring with the snap ring pliers, and insert the bearing part-way into the housing.





4. Release the pliers, then push the bearing down into the housing until the snap ring snaps in place around it.





5. After installing the bearings verify the following:
- The snap rings (A) are seated in the bearing and housing grooves.
- The ring end gaps (B) are correct.