How to End A Troubleshooting Session

PCM RESET
This command clears stored specific data from each vehicle such as DTC and Freeze Data. It does not clear CKP PATTERN data.

1. Do the PCM RESET in the CLEAR MENU with the Honda PGM Tester or the HDS with the engine stopped.
2. Turn the ignition switch OFF.
3. Turn the ignition switch ON (II). Wait for 30 seconds.
4. Turn the ignition switch OFF, and disconnect the Honda PGM Tester or the HDS from the DLC.

How to End a Troubleshooting Session (required after any troubleshooting)
1. Do the PCM RESET in the CLEAR MENU with the Honda PGM Tester or the HDS.
2. Do the PCM idle learn procedure.
3. Turn the ignition switch OFF.
4. Disconnect the Honda PGM Tester or the HDS from the DLC.

NOTE: The PCM is part of the immobilizer system. If you replace the PCM, it will have a different immobilizer code. In order for the engine to start, you must rewrite the immobilizer code with the Honda PGM Tester or the HDS.