Functional Setup

Functional Setup




Select the item you want to check.

Log Data
This screen allows the factory to collect log data to troubleshoot navigation system issues.




- Normally there is no card in the "PC Card slot", and the PC slot door should always be closed.




- However, if the factory provides a PC card and instructs you to insert it into the card slot (label side up), and then slide the PC Card door shut. If instructed by the factory, select "Gyro. Sensor Logs ON". Follow the factory procedure for gathering test data, and properly ending the test.

GPS Send Time
This screen is for factory use only, do not adjust. It allows adjustment of the GPS time. This display updates in real time.
- "GPS Time" is the time as received from the GPS satellites. It is in Greenwich Mean Time (GMT).
- "System Time" is the internal time used by the navigation unit to calculate your position on the map. It is also in Greenwich Mean Time (GMT).
- "Display Time" is the time shown on Setup screen 2 "Adjust Time Zone/Clock", and reflects any changes due to daylight savings time or time adjustments entered by the customer.




- Date, Hour, Minute, and "Set" should not be used.

Mic Level
This diagnostic allows you to independently test the microphone and the ON Hook and OFF Hook switch buttons. They are used to activate the voice control system. The microphone is located near the map light in the ceiling. It is directional, and works best if the voice is coming from the drivers seat.

- Press the ON Hook switch button on the steering wheel, and in a normal voice say "testing". The TALK indicator on the screen should momentarily become green, and the text "Now Recording..." should appear in yellow. In addition, the Mic Level indicator should move at least to the 6"' bar. If the Talk indicator on the screen does not briefly become green, then check the wiring from the ON Hook switch button to the navigation unit. If there is no "Mic Level" movement when you speak, then you should check the wire running from the microphone to the control unit.




- Press the OFF Hook switch button on the steering wheel. This should cause the Cancel indicator on the screen to momentarily become green. If it does not briefly change to green, then check the wiring from the steering wheel OFF Hook switch button to the navigation unit.