A/T Clutch Pressure Control Solenoid Valve C Test
A/T Clutch Pressure Control Solenoid Valve C Test
1. Connect the HDS to the DLC (A).
2. Choose Clutch Pressure Control (Linear) Solenoid C in Miscellaneous Test Menu on the HDS.
3. Test the A/T clutch pressure control solenoid valve C with the HDS.
4. Follow the instructions on the HDS.
- If the test result is OK, the valve is OK.
- If the test result is not OK, go to step 5.
5. Make sure you have the anti-theft codes for the radio and navigation system, and write down the audio presets.
6. Remove the left side engine compartment cover.
7. Make sure the ignition switch is OFF. Disconnect the negative cable from the battery first, then disconnect the positive cable.
8. Remove the battery hold-down bracket, then remove the battery and battery tray.
9. Remove the air intake cover and air intake tube.
10. Remove the splash shield.
11. Remove the two bolts securing the battery base from under the vehicle, and remove the two bolts securing the battery base in the engine compartment, then remove the battery base.
12. Disconnect the A/T clutch pressure control solenoid valve C connector and check the connector for pin fit, corrosion, dirt, and oil. If the connectors are OK, go to Step 13.If the connector is not OK, repair the connector and do the test again.
13. Measure the resistance between the A/T clutch pressure control solenoid valve C connector terminals.
Standard: 3 - 10 Ohms
14. If the resistance of the solenoid valve is out of standard, replace A/T clutch pressure control solenoid valve C.
15. If the resistance is within the standard, connect the battery negative terminal to A/T clutch pressure control solenoid valve C connector terminal No. 2, and connect the battery positive terminal to the terminal No. 1.
- If a clicking sound is heard, go to step 24.
- If no clicking sound is heard, go to step 16 and remove A/T clutch pressure control solenoid valve.
16. Remove A/T clutch pressure control solenoid valve C.
17. Remove the gasket (A) and 8 x 12 mm ATF feed pipe (B).
18. Connect the battery negative terminal to A/T clutch pressure control solenoid valve C connector terminal No. 2, and connect the battery positive terminal to the terminal No. 1.Make sure A/T clutch pressure control solenoid valve C moves.
19. Disconnect one of the battery terminals and check valve movement at the fluid passage in the valve body mounting surface.
20. If the valve binds or moves sluggishly, or if the solenoid valve does not operate, replace A/T clutch pressure control solenoid valve C.
21. Check the fluid passage of the A/T clutch pressure control solenoid valve for dust and dirt, and clean the passage if necessary.
22. Install the 8 x 12 mm ATF feed pipe with its filter side into the transmission housing.
23. Install the new gasket in the mounting groove of the A/T clutch pressure control solenoid valve C body properly, then install A/T clutch pressure control solenoid valve C on the transmission housing. Do not pinch the gasket.
24. Check the A/T clutch pressure control solenoid valve C connector for rust, dirt, or oil, then connect it securely.
25. Install the battery base, then install the air cleaner housing and air intake duct.
26. Install the air intake cover and air intake tube.
27. Install the splash shield.
28. Install the battery tray, battery, and battery hold down bracket.
29. Clean the battery posts and cable terminals with sandpaper, then assemble them and apply grease to prevent corrosion.
30. Install the left side engine compartment cover.
31. Enter the anti-theft codes for the radio and navigation system, then enter the audio presets, and set the clock.