Programming and Relearning

Resetting the Power Window Control Unit

Resetting the power window control unit is required when any of the following have occurred:
- Power window regulator replacement or repair.
- Power window motor replacement or repair.
- Window run channel replacement.
- Door glass replacement or repair.
- Driver's MPCS unit replacement.
- Front passenger's MPCS unit replacement.
- Power is removed from the Driver's or front passenger's MPCS unit while the power window timer is ON.

NOTE: If the passenger's window has lost power when the key off timer is ON, it cannot be operated from the driver's switch and must be reset from the passenger's power window switch.

Using the HDS

1. Connect the HDS to the data link connector.
2. Turn the ignition switch ON (II), then enter the vehicle's VIN and mileage at the prompts.
3. Select "BODY ELECTRICAL" from the "SYSTEM SELECT" menu.
4. From the "BODY ELECTRICAL SYSTEM SELECT" menu, select "POWER WINDOWS".
5. From the "MODE" menu, select "ADJUSTMENTS".
6. From the "ADJUSTMENT" menu, select "WINDOW PRESET" for driver's side (passenger's side) window.
7. Follow the prompts on the screen.
8. Confirm that the power window control unit is reset by using the window AUTO UP and AUTO DOWN function.

Without the HDS

NOTE: Do each bullet in step 4 within 5 seconds of each other.

1. Turn the ignition switch ON (II).
2. Move the window all the way down by using the window DOWN switch.
3. Open the driver's door.
4. Do the following 3 times before going to step 5:
- Turn the ignition switch to LOCK (0).
- Push and hold the window DOWN switch.
- Turn the ignition switch ON (II).
- Release the window DOWN switch.

5. Confirm that AUTO UP no longer works. If AUTO UP still works, go back to step 1.
6. Move the window all the way down using the window DOWN switch.
7. Pull up and hold the window UP switch until the window is all the way up, then continue to hold the switch for 1 second.
8. Confirm that the power window control unit is reset by using the window AUTO UP and AUTO DOWN function.

If the window still does not work in AUTO, repeat the procedure several times, paying close attention to the 5 second time limit between steps. If it still does not work, go to B-CAN System Diagnosis Test Mode A. Troubleshooting - B-CAN System Diagnosis Test Mode A

NOTE: The passenger's window must be rest from the passenger's power window switch.