Sun Visor: Service and Repair

Sunvisor Removal/Installation

Special Tools Required
KTC trim tool set SOJATP20T4 *
* Available through the American Honda Tool and Equipment Program.

NOTE:
- Put on gloves to protect your hands.
- Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.
- Take care not to bend or scratch the trim and panels.




1. From both sides, using a trim tool, release the tabs (A) from the bracket (B).




2. Remove the sunvisor cap (A) from the bracket (B). Turn the cap, and remove it.




3. Remove the sunvisor (A).
1. Using a T25 TORX bit, remove the self-tapping ET screws.
2. Remove the sunvisor from the body and holder (B).
3. Disconnect the vanity mirror light connector (c).




4. Using a flat-tip screwdriver, push the hook (A), and turn the holder (B) 90 °, then pull it out.




5. Install the sunvisor in the reverse order of removal, and note these items:
- If the side curtain airbag has deployed, replace the sunvisor with a new one.
- To prevent the side curtain airbags from deploying improperly and possibly causing injury, inspect removed pieces and replace them if they have any of these types of damage:
- Any cracks in the sunvisor stay base (A)
- Any bends or cracks in the sunvisor stay shaft (B)
- Any cracks in the sunvisor base (C)
- Any cracks or breakages in the vanity mirror base (D)

- If the threads on a visor screws are worn out, use an oversized self-tapping ET screw, P/N 90137-S30-003, made specifically for this application.