Cowl Moulding / Trim: Service and Repair

Cowl Cover Replacement

Special Tools Required

- KTC Trim Tool Set SOJATP2014
*Available through the Acura Tool and Equipment Program; 888-424-6857

NOTE:

- Put on gloves to protect your hands.
- Take care not to scratch the cowl covers or the body.
- Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.

1. Remove the these items:

- Windshield wiper arms Wiper Motor Replacement.
- Front fender trim, both sides .

2. From both sides of the cowl cover, release the hooks (A) from the cowl cover (B) and the front fender (C), then release the hood hinge cover (D) from roof molding (E), then remove the covers.






3. Remove the passenger's cowl cover (A).

1. Remove the hood rear seal (B) by pulling it out.

2. Remove the clip (C).

3. Release two front hooks (D) from the edge of the cover.

4. Detach the clips (E, F) by carefully pulling the cover upward, then remove the cover. Take care not to scratch the body.





4. Disconnect the windshield washer tubes (G).

5. Remove the driver's cowl panel (A).

1. Remove the clips (B).

2. Release two front hooks (C) from the edge of the cover.

3. Detach the clips (D, E) by carefully pulling the cover upward, then remove the cover. Take care not to scratch the body.





6. Install the cover in the reverse order of removal, and note these items:

- If the clips are damaged or stress-whitened, replace them with new ones.
- Make sure the washer tube is connected securely.
- Push the clips and the hooks into place securely.