Sun Visor: Service and Repair

Sunvisor Removal/Installation

Special Tools Required

- KTC Trim Tool Set SOJATP2014
*Available through the Acura Tool and Equipment Program; 888-424-6857

NOTE:

- Put on gloves to protect your hands.
- Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
- Take care not to bend or scratch the sunvisor or the headliner.

1. From both sides, using a trim tool, release the tabs (A) from the bracket (B).






2. Remove the sunvisor cap (A) from the bracket (B). Turn the cap, and remove it.






3. Remove the sunvisor (A).

1. Using a TORX T25 bit, remove the self-tapping ET screws.

2. Remove the sunvisor from the body and the holder (B).

3. Disconnect the vanity mirror light connector (C).





4. Using a flat-tip screwdriver, push the hook (A), and turn the holder (B) 90 °, then pull it out.






5. Install the sunvisor in the reverse order of removal, and note these items:

- If the side curtain airbag has deployed, replace the sunvisor with a new one Service and Repair.
- To prevent the side curtain airbags from deploying improperly and possibly causing injury, inspect the removed pieces and replace them if they have any of the following damage:
- Any cracks in the sunvisor stay bracket (A)
- Any bends or cracks in the sunvisor stay shaft (B)
- Any cracks in the sunvisor base (C)
- Any cracks or breakage in the vanity mirror base (D)
- Make sure the connector is plugged in properly.