Vanity Mirror Light Test/Replacement

Vanity Mirror Light Test/Replacement

1. Remove the sunvisor Service and Repair.

2. Disconnect the 2P connector (A) from the sunvisor (B).





3. Check for continuity between terminals No. 1 and No. 2 with the sunvisor fully retracted.

- With the vanity mirror cover (C) opened, there should be continuity.
- With the vanity mirror cover closed, there should be no continuity.

4. If the continuity is not as specified, go to step 5.

5. Carefully pry off the lens (A) with a small screwdriver.









6. Remove the two screws, then remove the vanity mirror light (B).

7. Disconnect the two terminals (C) from the vanity mirror light.

8. Check for continuity between the terminals.

- There should continuity between the terminals with the vanity mirror cover opened.
- There should be no continuity between the terminals with the vanity mirror cover closed.

9. If the continuity is not as specified, check the bulb (D). If the bulb is OK, replace the vanity mirror light. If the vanity mirror light is OK, replace the sunvisor Service and Repair.

10. Install the vanity mirror light in the reverse order of removal.