Ambient Light Test/Replacement

Ambient Light Test/Replacement

NOTE: The ambient light is built into the moonroof switch.

1. Remove the individual map lights. Service and Repair

2. Disconnect the moonroof switch 12P connector (A) and the map light 3P connector (B).

3. Remove the moonroof switch (C) from the map light housing.

4. At the moonroof switch side, check the light by connecting battery power to terminal No. 3 and ground to terminal No. 1. The ambient light should come on. If the light does not come on, replace the moonroof switch assembly.

5. Install the parts in the reverse order of removal.