A/T Housing Bearing Installation

A/T Housing Bearing Installation

Special Tools Required

- Attachment, 78 x 80 mm 07NAD-PX40100
- Driver handle, 15 x 135L 07749-0010000
- Attachment, 42 x 47 mm 07746-0010300
1. Install the bearings in the direction shown.

2. Expand each snap ring using snap ring pliers, and install the mainshaft bearing (A) and the countershaft bearing (B) part-way into the transmission housing using the driver handle and the 78 x 80 mm attachment.

3. Release the snap ring pliers, then push the bearing down into the transmission housing until the snap ring snaps in place around it.






4. Expand each snap ring of the secondary shaft bearing (A) and the idler gear shaft bearing (B) using the snap ring pliers, and install the bearings part-way into the transmission housing using the driver handle and the 42 x 47 mm attachment.

5. Release the snap ring pliers, then push the bearings down into the transmission housing until the snap ring snaps in place around it.






6. After installing the bearings, check that the snap rings (A) are seated in the bearing and the transmission housing grooves, and that the snap ring end gaps (B) are correct.

7. Install the idler gear shaft. Idler Gear Shaft Removal/Installation