M/T Main shaft Bearing and Oil Seal Replacement

M/T Mainshaft Bearing and Oil Seal Replacement

Special Tools Required

- Oil seal driver, 65 mm 07JAD-PL90100
- Adjustable bearing puller, 20-40 mm 07736-A01000B
- Bearing driver attachment, 42 x 47 mm 07746-0010300
- Driver handle, 15 x 135L 07749-0010000Slide hammer, 3/8''-16 UNF commercially available
1. Remove the ball bearing (A) from the clutch housing (B) using the 20-40 mm adjustable bearing puller (C) and a commercially available 3/8''-16 UNF slide hammer (D).






2. Remove the oil seal (A) from the clutch housing. Be careful when removing the oil seal so the clutch housing is not damaged.






3. Drive in a new oil seal from the transmission side using the 15 x 135L driver handle (A) and the 42 x 47 mm bearing driver attachment (B).






4. Drive in a new ball bearing (A) from the transmission side using the 65 mm oil seal driver (B).