2-6

Active Damper System DTC Troubleshooting: 2-5, 2-6

DTC 2-5:

Right-front/Right-rear Suspension Stroke Sensor Range/Performance Problem

DTC 2-6:

Left-front/Left-rear Suspension Stroke Sensor Range/Performance Problem

1. Turn the ignition switch to LOCK (0).

2. Remove the appropriate suspension stroke sensor Service and Repair. Do not disconnect the sensor connector.

NOTE: After troubleshooting for the left side suspension stroke sensor, do the headlight initial position learning procedure Programming and Relearning.






3. Start the engine, and wait 5 seconds.

4. Check the SUS STROKE_S VOLTAGE (RF), (LF), (RR), or (LR) in the ACTIVE DAMPER SYSTEM DATA LIST with the HDS while moving the suspension stroke sensor arm through a complete stroke. Compare the voltage/rotation angle between the chart and the measurements.

NOTE: The voltage should increase (decrease) within 90 degrees of the sensor arm rotation from the first voltage change point.





Is the voltage as specified?

YES -

Replace the active damper control unit Service and Repair.�

NO -

Replace the appropriate suspension stroke sensor Service and Repair.�