Power Mirror Motor: Service and Repair

Power Mirror Actuator Replacement

Actuator Replacement

1. Remove the mirror holder Mirror Holder Replacement.

2. Remove the three tamperproof TORX screws from the actuator (A) using a T10 TORX bit.





3. Remove the connectors (B) and the actuator.

4. Install the actuator in the reverse order of removal.

Actuator Harness Replacement

1. Remove the mirror holder Mirror Holder Replacement.

2. Remove the power mirror Power Mirror Replacement.

3. Remove the three tamperproof TORX screws from the actuator (A) using a T10 TORX bit.





4. Remove the four tamperproof TORX screws from the housing (B) using a T10 TORX bit.

5. Disconnect the connectors from the actuator and the side turn signal light.

6. Remove the gasket (C) and the harness (D) from the power mirror.

7. Route the wire harness of the new actuator through the hole in the bracket and the gasket in the reverse order of removal.

8. Connect the connectors to the actuator and the side turn signal light securely.

9. Install the actuator, housing and the gasket in the reverse order of removal.

10. Install the power mirror on the door, and then install the mirror holder in the power mirror.

11. Make sure the actuator, mirror defogger, and side turn signal light operate properly.