Headlamp Alignment Actuator: Service and Repair

Headlight Leveling Motor Replacement

Removal

1. Remove the headlight assembly Headlight Replacement.

2. Slightly pull the headlight leveling motor (A) back so that its projection (B) clears the stopper (C), and then rotate the motor 45 ° counterclockwise.





3. Turn the adjuster (D) of the headlight leveling motor until the headlight leveling motor shaft (E) is removed from the headlight.

Installation

1. Insert the headlight leveling motor shaft (A) into the headlight housing, then turn the adjuster (B) until the shaft connects to the headlight.





2. Slightly pull the headlight leveling motor (C) back so that its projection (D) clears the stopper (E), and then rotate the motor 45 ° clockwise to install to the headlight.

3. Tighten the adjuster until it is fully secure, but do not over tighten, then back it off 9 turns.

4. Insert the headlight in the reverse order of removal.

5. After installing, do the headlight leveling motor initial position learning procedure Programming and Relearning