Hazard Warning Switch: Service and Repair

Hazard Warning Switch Test/Replacement

1. Remove the center panel Dashboard Center Panel Removal/Installation.

2. Disconnect the 6P connector (A) from the hazard warning switch (B).





3. Remove the hazard warning switch from the center panel.

4. Check for continuity between the terminals in each switch position according to the table.





5. If the continuity is not as specified, replace the bulbs (C) or the hazard warning switch.

NOTE: Both illumination bulbs are connected in parallel. If there is continuity, remove the upper, passenger's airbag cutoff indicator illumination bulb, and recheck for continuity. If there is no continuity, replace the lower, hazard warning switch illumination bulb.