Key Interlock Solenoid Test

Key Interlock Solenoid Test

NOTE: SRS components are located in this area. Review the SRS component locations Locations, precautions and procedures Service and Repair before doing repairs or servicing.

1. Remove the steering column covers Service and Repair.

2. Disconnect the steering lock assembly 6P connector (A), and then turn the ignition switch to ACCESSORY (I).






3. Connect power to steering lock assembly 6P connector terminal No. 4, and ground steering lock assembly 6P connector terminal No. 3, then try turning the ignition switch to LOCK (0); the ignition switch should not turn.

4. Disconnect power and ground from terminals, then turn the ignition switch to LOCK (0) and remove the key; the ignition switch should turn and the key can be removed.

5. If the key interlock solenoid does not work as specified, replace the steering lock assembly Service and Repair.