2607 (Canada Models)

Navigation System DTC Troubleshooting: 2607

DTC 2607:

XM Diag

Canada models

NOTE:

- Check the vehicle battery condition first Testing and Inspection.
- This navigation DTC sets when a problem (open or short) is detected in the GA-Net BUS.
- Check any official Honda service website for more service information about the navigation system.
- Before you troubleshoot, make sure to follow the general troubleshooting information How to Troubleshoot the Navigation System.

1. Clear the hard error code.

2. Turn the ignition switch to LOCK (0) and then back to ON (II).

3. Check the hard error code.

Is DTC 2601 indicated at the time you cycled the vehicle?

YES -

Do the 2601 troubleshooting 2601.

NO -

Go to step 4.

4. Go into the System Diagnostic Mode, and select the Self-Diagnosis Mode.

5. Check the System Links.

Is the XM icon red?

YES -

Go to step 6.

NO -

Intermittent failure, the system is OK at this time.�

6. Turn the ignition switch to LOCK (0).

7. Check for poor connections or loose terminals at these items:

- Navigation display unit 28P connector
- XM receiver connector A (14P) and B (2P)

Are there connections OK?

YES -

Go to step 8.

NO -

Repair poor connections or loose terminals.�

8. Disconnect these items:

- XM receiver connector A (14P)
- Navigation display unit 28P connector
- Audio unit connector B (14P)
- USB adapter control unit connector A (14P)
- HandsFreeLink control unit 28P connector

9. Connect the XM receiver connector A (14P) terminals No. 9 and No. 10 with a jumper wire.






10. Check for continuity between navigation display unit 28P connector terminals No. 3 and No. 17.





Is there continuity?

YES -

Do the XM receiver troubleshooting.�

NO -

There is an open in the wire(s) between the navigation display unit and the XM receiver. Replace the affected shielded harness.�