92-1x

SRS DTC Troubleshooting: 92-1x

DTC 92-1x ("x" can be 0 thru 9 or A thru F):

Short to power in Passenger's Airbag Cutoff Indicator

NOTE:

- Information marked with an asterisk (*) applies to models with the navigation system.
- Before doing this troubleshooting procedure, review SRS Precautions and Procedures Service and Repair, General Troubleshooting Information Reading and Clearing Diagnostic Trouble Codes, and Battery Terminal Disconnection and Reconnection Procedures.
- If there are other SRS DTCs stored with 92-1x; troubleshoot them first.

1. Clear the DTCs with the HDS.

2. Turn the ignition switch to ON (II), then wait for 10 seconds.

3. Check for DTCs with the HDS.

Is DTC 92-1x indicated?

YES -

Go to step 4.

NO -

Intermittent failure, the system is OK at this time. Go to Troubleshooting Intermittent Failures. If another DTC is indicated, troubleshoot the DTC.�

4. Turn the ignition switch to LOCK (0).

5. Remove the center panel Dashboard Center Panel Trim Removal/Installation, and disconnect its connectors.

6. Disconnect the negative cable from the battery, then wait at least 3 minutes.

7. Disconnect SRS unit connector A (28P) from the SRS unit.

8. Reconnect the negative cable to the battery.

9. Turn the ignition switch to ON (II).

10. Measure the voltage between body ground and SRS unit connector A (28P) terminal No. 13. There should be less than 0.2 V.





Is the voltage as specified?

YES -

Faulty SRS unit or passenger's airbag cutoff indicator; replace the audio switch panel Audio Switch Panel Removal/Installation (Without Navigation System) or *navigation switch panel Service and Repair, then clear the DTC. If the DTC is still present, replace the SRS unit SRS Unit Replacement.�

*: With navigation system

NO -

Short to power in the dashboard wire harness; replace the dashboard wire harness, then clear the DTC.�