H
DTC Troubleshooting: B1232 (H)
DTC B1232 or DTC indicator H:
A Short in the Evaporator Temperature Sensor Circuit
NOTE: If DTC B1232 is detected with HDS, it is not necessary to do step 1.
1. Check the sensor input display mode, and select "evaporator temperature" according to the table.
NOTE: This indication by segment lit on digital segments is assigned for 2 failure causes that it is necessary to decide which one is a true cause. If there is a failure in the sensor or motor, a value corresponded to the sensor or motor in the Sensor Input Display Mode is displayed as "Er", which serves to specify which is a true cause.
Is sensor value indicated "Er"?
YES -
Go to step 2
NO -
Go to troubleshooting DTC B1205 or DTC indicator H B1205
2. Clear the DTC with the HDS.
3. Turn the ignition switch to LOCK (0), and then back to ON (II).
4. Do the self-diagnostic with the HDS or the climate control unit.
5. Check for DTCs.
Is DTC B1232 or H indicated?
YES -
Go to step 6.
NO -
Intermittent failure. Check for loose wires or poor connections on the evaporator temperature sensor circuit.�
6. Turn the ignition switch to LOCK (0).
7. Test the evaporator temperature sensor Evaporator Temperature Sensor Test.
Is the evaporator temperature sensor OK?
YES -
With the evaporator temperature sensor disconnected, go to step 8.
NO -
Replace the evaporator temperature sensor Service and Repair.�
8. Disconnect climate control unit connector A (24P).
9. Check for continuity between body ground and climate control unit connector A (24P) terminal No. 13.
Is there continuity?
YES -
Repair a short to body ground in the wire between the climate control unit and the evaporator temperature sensor.�
NO -
Go to step 10.
10. Check for continuity between climate control unit connector A (24P) terminals No. 13 and No. 18.
Is there continuity?
YES -
Repair a short in the wires between the climate control unit and the evaporator temperature sensor.�
NO -
Substitute a known-good climate control unit, and recheck. If the symptom/indication goes away, replace the original climate control unit Climate Control Unit Removal/Installation.�