Power Mirror Motor: Service and Repair

Power Mirror Actuator Replacement

1. Remove the mirror holder Mirror Holder Replacement.

2. Remove the mirror visor Service and Repair.

3. Remove the power mirror Power Mirror Replacement.

4. Disconnect the 14P connector from the mirror.

5. Remove the three TORX screws using a tamper-proof T10 TORX bit, then remove the actuator (A).






6. Remove the connectors (A), then remove the screw (B) and separate the harness (C) from the power mirror.





7. Route the wire harness of the new actuator through the hole in the bracket (D) and the gasket (E).

8. Install the actuator, the harness, and the gasket in the reverse order of removal.