Operation CHARM: Car repair manuals for everyone.
Home >> Acura >> 2012 >> TL FWD V6-3.5L >> Repair and Diagnosis >> Powertrain Management >> Fuel Delivery and Air Induction >> Accelerator Pedal Position Sensor >> Service and Repair
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Accelerator Pedal Position Sensor: Service and Repair




Accelerator Pedal Module Removal and Installation

Removal

1. Remove the driver's dashboard undercover Driver's Dashboard Undercover Removal / Installation.

2. Disconnect the APP sensor 6P connector (A).





3. Remove the two mounting nuts (B), then remove the clip (C). Using a flat-tip screwdriver (D), push the lock (E), then remove the accelerator pedal pad (F) from the pedal stop (G).

4. Remove the accelerator pedal module.

NOTE:

- The APP sensor is not available separately. Do not disassemble the accelerator pedal module.
- If the pedal stop is damaged, replace it by pulling back the carpet (A), and removing the nuts (B), the bolt (C), and the pedal stop (D).






Installation

1. Install the accelerator pedal pad (A) to the pedal stop (B). Slide the pad until it locks with a clicking sound.






2. Install a new clip (A).

NOTE:

- The clip must be replaced whenever the accelerator pedal module is installed.
- Make sure that the accelerator pedal module and the clip are secure.





3. Install the nuts (B), and connect the APP sensor 6P connector (C).

pro multis · About Operation CHARM