Hazard Warning Switch Test/Replacement

Hazard Warning Switch Test/Replacement

1. Remove the audio-navigation switch panel*1 Audio-Navigation Switch Panel Removal/Installation or audio unit*2 Audio Unit Removal / Installation.

*1: With navigation
*2: Without navigation

2. Disconnect the 5P connector (A) from the hazard warning switch (B).





3. Remove the two screws and the hazard warning switch.

4. Check for continuity between the terminals in each switch position according to the table.





5. If the continuity is not as specified, check the bulbs (C). If the bulbs is OK, replace the hazard warning switch.

6. Install the switch in the reverse order of removal.