Operating Rods For Rear Door Lock

Operating rods for rear door lock, removing and installing







1 - Operating rod
Adjusting :
- Engage operating rod in hinged clip -2-.
- Attach operating rod to operating clip -3- without straining activation lever on door handle (max. play 1.5 mm).
- Slide up casing -4- on operating clip -3- to engage.
- Clip length -4a- 13 ± 3 mm.
- Do not pull locating pin -4- out of door lock until after installing operating rod.
2 - Hinged clip
3 - Operating clip
4 - securing pin
- Only present for replacement parts, helps secure in basic position
- Do not remove until after installing operating rod -1-
5 - Bowden cable for door lock
- Removing and installing see Fig. 1.

Fig. 1 Removing and installing Bowden cable for door lock







- To remove, detach bowden cable -2- from mount -1- and unclip from cable guide -3-.