Output Diagnostic Test Mode (Scan Tool Function 03)

Output Diagnostic Test Mode (Scan Tool Function 03)


NOTE:
- The Output Diagnostic Test Mode may only be performed with the vehicle stationary and the engine not running.
- Any malfunctions identified by the Output Diagnostic Test Mode must be checked and repaired.


The output DTM activates the following elements in sequence:
- Emergency flashers and anti-theft horn (only for vehicles equipped with anti-theft system)
- Interior monitoring (activated even if interior monitoring is not installed)
- Emergency flashers and interior lights as a test of the crash signal

Carrying out "Output Diagnostic Test Mode" function 03

Indicated on display


Rapid data transfer HELP
Select function XX


- Press buttons -0- and -3- to select "Output Diagnostic Test Mode" function 03.

Indicated on display


Rapid data transfer Q
03 - Output Diagnostic Test Mode


- Press -Q- button to confirm input.

Indicated on display (emergency flasher and anti-theft horn are activated)


Output Diagnostic Test Mode ->
Create active alarm


- Press -> button.

Indicated on display


Output Diagnostic Test Mod ->
Next final ctrl: operate ->


- Press -> button.

Indicated on display (central locking control module sends a signal which activates interior monitoring system)


Output Diagnostic Test Mode ->
Activate interior monitoring


NOTE:
- After activating interior monitoring, a system dependant waiting time of 30 seconds must be maintained.
- If one alarm is activated, an entry into DTC memory of the control module for central locking will be made "1370; alarm via interior monitoring" as well as That control module for ultra-sound sensors "alarm via sensor for anti-theft warning system; fl, fr, rl, rr".
- Malfunctions must be checked and erased in DTC memory of the respective control module.


- Press -> button.

Indicated on display


Output Diagnostic Test Mode ->
Next final ctrl: Operate ->


- Press -> button.

Indicated on display (emergency flashers and interior lights are triggered)


Output Diagnostic Test Mode ->
Simulate crash signal


- Press -> button.


NOTE:
- The malfunction "1366; opening via crash-signal" is stored in DTC memory of the control module for central locking.
- Output Diagnostic Test Mode (DTM) must be repeated with airbag control module. After performing output Diagnostic Test Mode (DTM) of airbag control module, DTC "01366 opening via crash signal" will also be stored in control module for central locking.
- The malfunction must be checked in DTC memory of the control module for central locking and erased.

Indicated on display


Output Diagnostic Test Mode ->
END


- Press -> button.

The program is now back at its starting point.

Indicated on display


Rapid data transfer HELP
Select function XX