Driver-Side Airbag For Sport Steering Wheel (Up to m.y. 1998), Removing and Installing

Driver-Side Airbag For Sport Steering Wheel (up Tom.y. 1998), Removing And Installing







WARNING: Follow all safety precautions when working on airbags.

1 - Bolts to secure upper part of carrier unit
- 5 Nm (44 in.lb)
2 - Harness connector for airbag unit
3 - Airbag unit
4 - Nut for steering wheel
- 42 Nm (31ftlb)
5 - Bolts to secure lower part of carrier unit.
- 5 Nm (44 in.lb).
6 - Torx(R) bolt(T30)
- 6 Nm (53 in.lb)
7 - Securing cable for spiral spring







8 - Spiral spring
9 - Journal
10 - Transportation protection

Removing
- Unbolt airbag unit from behind using Torx(R) wrench (T30).
- Remove airbag unit - 3 - and disconnect harness connector - 2 -.
- Place airbag unit on appropriate surface with impact padding facing up.

Installing

NOTE:
- Make sure harness connector - 2 - audibly engages (clicks).
- When installing airbag unit, first tighten right Torx(R) bolt.

WARNING: Make sure no one is in vehicle.

- Switch ignition on and connect battery Ground (GND) strap.