Removing and Installing: Overview

- Clamp final drive in assembly stand. Refer to "Procedures" at Pinion, Removing and Installing. Service and Repair
- Refer to general repair instructions. Service and Repair






1. Hex socket bolt
- 10 Nm (7 ft lb) plus additional 1/4-turn (90°)
2. Flanged shaft
3. Oil seal
- Pry out
- Drive in fully with 2062
4. Oil filler plug
- 25 Nm (18 ft lb)
5. Final drive housing
- With pinion
- Disassembling and assembling pinion: refer to "Overview" at Pinion, Removing and Installing. Service and Repair

Note: If these parts are replaced, adjustments are required. Refer to "List of Adjustments" at Rear Final Drive, Ring and Pinion Adjusting. Service and Repair

6. Oil drain plug
- 25 Nm (18 ft lb)
7. Breather
- Installation depth: refer to "Procedures"
8. Shim -S1-
- Note thickness
- Refer to "List of Adjustments" at Rear Final Drive, Ring and Pinion Adjusting. Service and Repair
9. Outer race for tapered roller bearing

Note: If these parts are replaced, adjustments are required. Refer to "List of Adjustments" at Rear Final Drive, Ring and Pinion Adjusting. Service and Repair

10. Differential
- Disassembling and assembling,
11. Outer race for tapered roller bearing
- Removing and installing, refer to Final Drive, Differential. Service and Repair

Note: If these parts are replaced, adjustments are required. Refer to "List of Adjustments" at Rear Final Drive, Ring and Pinion Adjusting. Service and Repair

12. Shim -S2-
- Note thickness
- List of adjustments. Refer to "List of Adjustments" at Rear Final Drive, Ring and Pinion Adjusting. Service and Repair

Note: If these parts are replaced, adjustments are required. Refer to "List of Adjustments" at Rear Final Drive, Ring and Pinion Adjusting. Service and Repair

13. Final drive cover
- Seal with AMV 188 200 03
- Installation position: Magnet faces downward

Note: If these parts are replaced, adjustments are required. Refer to "List of Adjustments" at Rear Final Drive, Ring and Pinion Adjusting. Service and Repair

14. Hex socket bolts
- 25 Nm (18 ft lb)
15. Locking ring for differential lock
- Installation position: refer to "Procedures"
16. Magnet
- Installation position: refer to "Procedures"
17. Oil seal
- Removing and installing, refer to Differential Output Shaft Seal. Service and Repair
18. Shim for flanged shaft
- Note thickness
- List of adjustments. Refer to "List of Adjustments" at Rear Final Drive, Ring and Pinion Adjusting. Service and Repair
19. Flanged shaft
- Adjusting, refer to Differential Output Shaft. Adjustments
20. Hex socket bolt
- 10 Nm (7 ft lb) plus additional 1/4-turn (90°)
21. Clip for magnet
- Always replace
- Installation position: refer to "Procedures"
22. Shim for locking ring
- Determine thickness: refer to "Procedures"
23. Operating sleeve