Split Rear Seat Backrest (Sedan), Removing and Installing

Split Rear Seat Backrest (Sedan), Removing And Installing







1 - 2/3 rear backrest
Removing:
- Remove bolt - 8 - and remove center mounting bracket clip - 7 -.
- Lift rear backrest out of center mounting bracket - 9 - and pull toward center of car out of fitting - 4 -.
Installing:
- Installation is the reverse of removal
2 - 1/3 rear backrest
- Removal and installation procedures are same as 2/3 rear backrest
3 - Bolts (2x)
- 16 Nm (12 ft.lb)
4 - Fitting
5 - Guide for rear backrest
6 - Bolt (4x)
- 16 Nm (12 ft.lb)







7 - Center mounting bracket clip
8 - Bolt
- 8 Nm (71 in.lb)
9 - Center mounting bracket
10 - Locking stirrup
11 - Rear panel
12 - Trunk trim
13 - Base plate
14 - Bolt
- 8 Nm (71 in.lb)