Reading Transmissions with hydraulic control -E18/2-

Read Measuring Value Block (Scan Tool Function 08) For Transmissions With Hydraulic Control -E18/2-


CAUTION!
To avoid risk of accidents during measuring and test drives, note safety precautions.


Procedure
- Connect VAS 5051 tester or V.A.G 1551 scan tool and select Transmission Control Module (TCM) using "address word" 02. Scan Tool Connecting and Initial Checks

Ignition must remain switched on for this procedure.

Indicated on display


Rapid data transfer HELP
select function XX


- Press PRINT button to turn on Scan Tool (ST) printer. Indicator lamp in button must light up.
- Press buttons -0- and -8- to select "Read Measuring Value Block" and press -0- button to confirm input.

When indicated on display:


Read measuring value block Q
Input display group number XXX


- Enter desired display group number, display group overview.
- Confirm input using the -Q- button.

Indicated on display (example) for display group 001:


Read measuring value block 1 ->
1 2 3 4


NOTE:
- Explanation of values in individual display fields test table. Evaluating Measured Value Blocks -E18/2-
- Display can be printed out when printer is switched on.
- To switch to a different display group, proceed as follows:







Indicated on display (function selection):


Rapid data transfer HELP
Select function XX


Overview of selectable display group numbers for transmission with hydraulic control - E18/2-


















NOTE:
- When the printer is switched on, the contents of the display will be printed out.
- If specified values are not obtained in all display fields:


- Press -> button.

Indicated on display


Rapid data transfer HELP
Select function XX