Remote Unit, Coding and Erasing
Memory addresses, codingOn vehicles with remote-control central locking, every new or non-encoded remote unit must first be re-coded for the central locking system control module.
- Switch ignition on and leave key in ignition.
- Use second key to lock vehicle at driver's side door.
- On remote unit, press "Open" button once.
Short horn signal will sound
NOTES:
- The "Open" button is pressed once for programming the first, or a single, remote unit.
- When programming additional remote units for the second, third or fourth memory addresses, press the "Open" button two, three or four times, in one-second intervals.
- For example, to program the second remote unit: press the "Open" button once, wait 1 second, then press again.
- After 6 seconds, press "Open" button once (to activate coding process).
The remote unit will now be coded, and it can be used to unlock the central locking system.
- Switch ignition off.
NOTE: The key must be removed from the ignition before the remote unit can be used to lock the vehicle.
The coding process can be repeated up to 4 times for additional remote units. After coding each remote unit, the ignition must be switched off.
Memory addresses, erasing
NOTE: It is possible to erase the memory, e.g. if the customer has lost a remote unit. Proceed as follows.
- Use key to switch ignition on.
- Use second key to lock vehicle at driver's side door.
- On remote unit, press "Open" button 5 times in one-second intervals.
Short horn signal will sound
- After 6 seconds, press "Open" button once to activate memory erasing process.
Memory is now erased, and the central locking system can no longer be operated by the remote unit.
- Switch ignition off.
As many as 4 new remote units can now be coded.