Fog/Driving Lamp: Service and Repair

Removing
- Remove screws -3-.
- Carefully pull inside edge of fog light -2- from front apron, then swing fog light outward and remove.
- Release fog light harness connector from retaining clip -5-, then disconnect.
- Remove fog light -2-.

Installing
- Connect fog light harness connector and insert into retaining clip -5-.
- Insert outside edge of fog light into opening so that hook-1-engages in front apron.
- Swing inside edge of fog light inward and install screws -3-.

Adjusting
- Turn adjustment screw -4- to adjust fog light until beam aligns with orientation line of headlight aiming equipment (commercially available).


NOTES:
- Only vertical adjustment of the fog lights is possible. The horizontal (side-to-side) aiming can not be adjusted.
- Adjust fog light aim using headlight aiming equipment (commercially available).