Bosch 5.3 - ABS/EDL/ASR

Has an ASR control module just been replaced or is one of the DTC's stored in DTC memory of the control module?
- "ABS/EDL transmission electrical connection"
- "Control module incorrectly coded"
- "CAN-bus missing signal from Transmission Control Module (TCM)"
If so, control module must be coded according to engine and transmission type.

Notes:
- Coding is only possible if a workshop number is stored in the VAG1551 Scan Tool (ST).
Refer to Operating instructions for VAG1551
- During control module identification the 5digit code will be indicated.

- Connect the VAG1551 Scan Tool (ST) and select address word 03 "Brake Electronics".
- Check the control module version and press the (arrow) button.
- Press (arrow) button.





Indicated on display:
- Press buttons -O- and -7- to select "Code control module" function 03.





Indicated on display:
- Press -Q- button to confirm input.





Indicated on display:
- Enter the appropriate code number and press -Q- button to confirm input.

Part 1 Of 4:

Part 2 Of 4:

Part 3 Of 4:

Part 4 Of 4:

Coding table ABS/EDL/ASR with CAN

1) 1.8 T means 1.8 Liter Turbo engine
2) 1.9 PD means 1.9 Liter injection Pump Diesel engine





- Display will indicate the control module identification and the coding entered (e.g. 00000).
- Press (arrow) button.





Indicated on display:
- Press buttons -0- and -6- to select "End Output" function 06. Press -Q- button to confirm input.