Lock Carrier, Service Position
Lock Carrier, Service Position
NOTE:
- Do not remove noise insulation panel.
- Loosen front quick-release screws only.
- Bumper must be removed.
1 - Lock carrier
For service position:
- Remove intake air duct between lock carrier and air cleaner housing at lock carrier.
- On right side, remove bolt -5- and install 3369 support tool.
- On left side, install 3369 support tool into threaded hole.
- Remove bolts -2- on left and right.
- Remove bolts -3- and -4- and pull lock carrier -1- forward.
- Secure lock carrier.
2 - Torx(R) bolts
- 10 Nm (7 ft lb)
3 - Bolt w/washer assembly
- 50 Nm (37 ft lb)
4 - Bolt w/washer assembly
- 50 Nm (37 ft lb)
5 - Bolt w/washer assembly
- 50 Nm (37 ft lb)
- For service position: remove bolt and install 3369 support tool
NOTE: After installing the lock carrier, check the headlight settings and adjust if necessary.